Division 10 — Specialties Lockers: Division 10 — Specialties is a category within the National Master Specification (NMS) set of guidelines developed by Public Works and Government Services Canada. Division 10 — Specialties items that could be required within a locker room (to meet commercial building and construction regulations) are lockers, washroom accessories, toilet compartments, and toilet partitions. Lockers are constructed of two sides: a back, top and a bottom. Different types of materials are used in locker manufacturing, offering a wide variety of metal lockers, stainless steel lockers, solid plastic lockers, solid phenolic lockers, and custom lockers. A padlock is the most common way to lock a locker; however, you can also use a keyed cylinder lock, built in combination locks or keypad locks. There are a lot of optional extras that can be utilized for lockers, for example: bases, sloping tops, end panels, customized shelves and hooks as well as the locking method (coin-operated lockers are another option). The environment is the best way to distinguish what type of locker will be required for which type of space. For example, if you are putting gym lockers into a humid area, or anywhere close to showers, stainless steel or solid plastic lockers would be most suitable because they are moisture-resistant and rust-resistant. Wood lockers would not be appropriate for this type of environment because the moisture from the humidity would rot the wood.
If you are paid through the fall semester, you must clean out your locker during finals week of the fall semester. If you are paid for fall and spring, you have to clean out your locker during finals week of the spring semester, but not during winter break between semesters. If you are paid through summer, you have to clean out your locker two weeks before school starts. Exception: If you renew your locker, you must clean your locker out by the end of the semester that you paid through, unless of course, it is through summer, and then you will need to clean out two weeks before the fall semester starts.
Number of locking points: Locker doors may lock with either single- or three-point locking, but this is not normally chosen as a separate option, and the choice is usually dependent on the number of tiers in the lockers, or whether they are a high-security model, although some manufacturers do allow purchasers to specifically choose an option here that goes against their normal practice. Single-point locking locks the door at only the point where the latch engages with the door-frame, whereas three-point locking uses extensible steel rods to lock the top and bottom of the door as well.
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together.

Buy Denver Lockers


At Shelving Rack & Lockers, Inc. we are always doing our part to recycle good industrial storage equipment. We are continually looking for quality used products that are in usable and sturdy condition. Doing so allows us to give you great products as well as incredible savings. Additionally, it helps us do our part to keep unnecessary items out of our landfills, making our environment more green.

Buy Locker Denver

×