Gun lockers or safes are specifically designed for the secure storage of guns and ammunition. They broadly resemble normal single-tier lockers, but tend to be slightly less high than normal single-tier lockers, and are often free-standing, and not banked together. They are fitted with internal racks designed for holding firearms. They have a shelf at the top like normal single-tier lockers, although in this case it is closed and locked by a separate door, because of legal requirements in some countries that firearms and ammunition be stored and locked separately. They always lock with three-point locking, which is in some countries a legal requirement for the storage of firearms. Sometimes they are made of the standard kind of sheet steel used in manufacturing normal lockers, and sometimes they are made of extremely thick heavy-duty steel and in this case resemble a safe more than a normal locker. In Australia there are strict regulations governing the storage of firearms following the Port Arthur massacre in Tasmania, Australia on 28 April 1996, and cabinets used for storing firearms must be bolted to the floor or a wall if the cabinet is under a certain weight. Dedicated gun lockers are likely to include holes in the cabinet to accommodate such bolting. Several locker manufacturers also offer dedicated gun lockers.
Investors should also pay attention to FL's average 20-day trading volume. Volume is a useful item in many ways, and the 20-day average establishes a good price-to-volume baseline; a rising stock with above average volume is generally a bullish sign, whereas a declining stock on above average volume is typically bearish. FL is currently averaging 2,544,457 shares for the last 20 days.
Laundry lockers are used in places like hospitals and food-processing workplaces where uniforms have to be collected, laundered, then returned to their owners. The locker cabinet contains a number of very narrow lockers, each of whose doors is keyed using a key held by the owner, so that they have access only to their own locker; but the entire array of doors is embedded in a much larger door covering the entire front of the cabinet. Opening this opens all the lockers simultaneously, and requires the use of a master key which is held by whoever collects items deposited in lockers, for laundering, then returned in the same way, after which they items are accessible to owners using their individual small doors.
Sloping tops: while most lockers have flat tops, some manufacturers offer the option of sloping tops to their range of lockers. The slope may be of either 30 degrees or 45 degrees to the horizontal, sloping towards the front, and the purpose of this is to make it impossible to store items on top of the lockers, or to make it harder for dust or other debris to accumulate there. This is an important factor in places like food-processing factories or restaurants where hygiene requirements must be met.
Stepped/2-step lockers are two-tier lockers, usually available only in 15-inch (38-cm.) width; but the compartments and their doors have an L-shaped cross-section, which causes the division between the doors to follow a zigzag pattern. This configuration enables more hanging height to be included in both upper and lower lockers; but part of each compartment (the lower part of the upper one and the upper part of the lower one) will be only half the usual width of two-tier lockers.
For longer term storage, there are many self storage units around the metro area. Not cheap, but then neither is paying extra baggage fees and lugging around extra stuff not needed for another leg of your trip, as it sounds like Terry might be doing. For example, I found "Downtown Denver Self Storage" with units starting at $45 a month. http://www.downtowndenverstorage.com/