Sloping tops: while most lockers have flat tops, some manufacturers offer the option of sloping tops to their range of lockers. The slope may be of either 30 degrees or 45 degrees to the horizontal, sloping towards the front, and the purpose of this is to make it impossible to store items on top of the lockers, or to make it harder for dust or other debris to accumulate there. This is an important factor in places like food-processing factories or restaurants where hygiene requirements must be met.
Bank size: It does not necessarily refer to the total number of compartments, but rather the number of compartments wide the entire cabinet is. So a bank of three may contain six lockers, for example, if they are two-tier lockers. In short, the total number of lockers is the bank size multiplied by the number of tiers. Sometimes the term "bay" is used instead of "bank", although "bank" appears to be the more standard term; on other occasions, "bay" refers to a single locker width within a bank, including all tiers of locker directly on top of each other.
The storage lockers were a “pilot,” the kind of small test that city government frequently uses to test a new or controversial idea. The city offered up the lockers for individuals to use for months-long stretches. At the time, city officials warned that “misuse of the lockers, vandalism, or other unanticipated results,” could force them to cancel the project.
Investors should also pay attention to FL's average 20-day trading volume. Volume is a useful item in many ways, and the 20-day average establishes a good price-to-volume baseline; a rising stock with above average volume is generally a bullish sign, whereas a declining stock on above average volume is typically bearish. FL is currently averaging 2,544,457 shares for the last 20 days.
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together.